Do Condenser Microphone Transformers Create Better Sound?

Reading spec sheets for microphones these days can make one’s eyes gloss over. So much is so similar. Yet, we know each mic sounds a bit different, which is where subtle creative differences come into play. One especially mystifying spec to many is whether or not a mic has a transformer. What does a mic transformer do and is it better with or without one?

Neumann CMV-5, 1947, with transformer

Neumann CMV-5, 1947, with transformer

First, a little background and history is needed on the question. In the earliest days of pro audio, transformers — for microphones and other gear — were used to provide electrical isolation between different equipment components and to create balanced interfaces to minimize buzz and hum. They were also used to match levels between different devices.

All professional studio condenser microphones, then and now, need a balanced output. Some kind of circuitry is needed to convert the ultra high impedance capsule signal to a low impedance output. Prior to the mid 1970s, these mic outputs were balanced by means of an output transformer.

For tube and early transistor electronics in condenser mics, the transformer was also used for the final part of the impedance conversion. A single tube or FET handled the first stage, while a step-down transformer handled the second stage of the mic's impedance conversion.

Schoeps V4 Transformerless Mic Circuit

Schoeps V4 Transformerless Mic Circuit

In the late 70s and early 80s, transformerless outputs came into play. Almost overnight, audio transformers were considered outdated technology. Not only did transformers cost more to produce, but removing them meant the audio from the microphone was cleaner. In those days, “colored” audio was considered something users did not want. Transparent, clean audio was in demand.

In today’s world, most new microphones have no transformers. Solid-state circuits have been developed to replace them. With good design, these circuits can out-perform transformers in almost every respect. They have far wider signal bandwidths with a more linear frequency response. Significantly lower distortion and considerably better phase and transient response are also benefits.

Neumann, a veteran German manufacturer of studio microphones with and without transformers, said audio transformers do indeed color the sound image, but not as much as people tend to think. Transformer balanced microphones offer smoother top end and deeper bottom end. Transformers show a slight resonance above 20 kHz, which gives the top end an airy feel. Transformers may also have a slight resonance at the lower end of the spectrum, which may give the impression of a fatter bottom end.

However, Neumann continued, transformerless microphones usually have a more extended response both in the high and the low frequencies. And, more importantly, transformerless microphones can take much more level without distortion.

Neumann Mic Transformer

Neumann Mic Transformer

As you might have guessed by now, the highly transparent sound of modern microphones can be too technically perfect for some discerning ears. Many of today's producers seek the vintage colored sound of older gear using transformers. Though at least 90 percent of a microphone’s sound is in the capsule, the transformer debate is a key reason vintage microphones remain in such high demand.

The subtle flaws of transformers lend a sonic character to a microphone that in many applications recordists enjoy. Some mics are used specifically to create a form of benign distortion in a recording. This is in fact a selling point for some mics still using transformers.

Use of transformers (or not) is still another reason that microphones are considered to be an artist’s paintbrush for sound. There is no right or wrong decision. 

You might also like...

NAB Show 2024 BEIT Sessions Part 2: New Broadcast Technologies

The most tightly focused and fresh technical information for TV engineers at the NAB Show will be analyzed, discussed, and explained during the four days of BEIT sessions. It’s the best opportunity on Earth to learn from and question i…

Standards: Part 6 - About The ISO 14496 – MPEG-4 Standard

This article describes the various parts of the MPEG-4 standard and discusses how it is much more than a video codec. MPEG-4 describes a sophisticated interactive multimedia platform for deployment on digital TV and the Internet.

Chris Brown Discusses The Themes Of The 2024 NAB Show

The Broadcast Bridge sat down with Chris Brown, executive vice president and managing director, NAB Global Connections and Events to discuss this year’s gathering April 13-17 (show floor open April 14-17) and how the industry looks to the show e…

Essential Guide: Next-Gen 5G Contribution

This Essential Guide explores the technology of 5G and its ongoing roll out. It discusses the technical reasons why 5G has become the new standard in roaming contribution, and explores the potential disruptive impact 5G and MEC could have on…

Comms In Hybrid SDI - IP - Cloud Systems - Part 1

We examine the demands placed on hybrid, distributed comms systems and the practical requirements for connectivity, transport and functionality.